545196757 Rev. 1 12/15/08 BRWINSTRUCTION MANUALIMPOR TANT INFORMATI ON: Please read these instructions carefully and makesure you understand them befo
10The carburetor has been carefully set at thefactory.Adjustments maybenecessary ifyounotice any of the following conditions:S Engine will not idle wh
11TROUBLE CAUSE REMEDYEngine will notstart.1. ON/OFF switch in OFFposition.2. Engine flooded.3. Fuel tank empty.4. Spark plug not firing.5. Fuel not r
12DECLARATION OF CONFORMITYEC Declaration of Conformity (Only applies to Europe)We, Husqvarna AB, SE-561 82 Huskvarna, Sweden, tel: +46--36--146000, a
13TECHNICAL DATA SHEETMODEL: TrimMac 250 LSENGINEDisplacement, cm325Maximum engine power, measured inaccordance with ISO 8893, kW 0,7Catalytic convert
2IDENTIFICATION (WHAT IS WHAT?)Assist HandleShieldTrimmerHeadShaftMufflerFuel MixFill CapStarter HandleON/OFF SwitchThrottle TriggerChoke LeverSpark P
3SAFETY RULESWARNING: When using gardeningappliances, basic safety precautions should al-ways be followed to reduce the risk of fire andserious injury
4S Stop engine and allow to cool before re-moving fuel cap.S Always store gasoline in a container ap-proved for flammable liquids.CUTTING SAFETYWARNIN
5ADJUSTING THE HANDLEWARNING: When adjusting the assisthandle,besureitremains above the safety labeland below the mark or arrow on the shaft.1. Loosen
6STAR TIN G A COLD ENGINE (or awarm engine after running out offuel)1. Set unit on a flat surface.2. Move ON/OFF switch to the ON position.3. Slowly p
7WARNING: Use only 2 mm diameterline.Othersizesandshapesof linewillnotad-vanceproperly andwill result in improper cut-tingheadfunctionor cancauseserio
8INSPECT AND CLEAN UNIT ANDLABELSS After each use, inspect complete unit forlooseordamagedparts. Cleantheunitandlabels using a damp cloth with a mildd
95. When installing new line on an existingspool, hold the spool as shown.6. Bend the line at the midpoint and insertthe bend into the slot in the cen
Comentários a estes Manuais