McCulloch MRT850 Manual do Operador descarregar pdf (Página 16)

SERVICE AND ADJUSTMENTS

CABLE CLIP

SCREW

DRIVE

CONTROL

CABLE

EXTENSION

SPRING

ENGINE

PULLEY

IDLER

PULLEY

TRANS MIS SION

PULLEY

LESS

TEN SION

5/8"

TEN SION

Fig. 24

TO REPLACE GROUND DRIVE BELT

(See Fig. 24)

• Remove belt guard as described in “TO REMOVE BELT

GUARD”.

• Remove old belt by slipping off engine pulley first then

remove from transmission pulley.

• Place new belt in groove of transmission pulley and

into engine pulley. BELT MUST BE IN GROOVE ON

TOP OF IDLER PULLEY. NOTE POSITION OF BELT

TO GUIDES.

• Check belt adjustment as described below.

• Replace belt guard.

• Reposition wheel and replace clevis pin and hairpin

clip.

GROUND DRIVE BELT ADJUSTMENT

(See Fig. 24)

For proper belt tension, the extension spring should have

about 5/8" (16 mm) stretch when tine control is in “EN-

GAGED” position. This tension can be attained as fol lows:

• Loosen cable clip screw securing the drive control

cable.

• Slide cable forward for less tension and rearward for

more tension until about 5/8" (16 mm) stretch is obtained

while the tine control is engaged.

• Tighten cable clip screw securely.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23 24

Comentários a estes Manuais

Sem comentários

McCulloch MRT850 Manual do Operador Página 16

Comentários a estes Manuais

Manuais e produtos relacionados com Mini-cultivadores McCulloch MRT850